A projection light is waiting for you to appear
High quality projection thousands of modifiction enthusiasts required.
01.Good quality brightness
With Corey LED beads, small size ,long life,light,color temperature standard.The perfect combination of high efficiency can be
achieved at extremely high driving current.
02.Irradiation angle in place
LOGO lights up to the ground 28 degree angle,showing a perfect projection angle.
0.3.Worry free and waterproof
By testing the host into the water,soak for 48 hours,can still be normal exposure,the effect is good.
Product Name: Car tail LOGO Lamp
Product life:10000 hours
Material: aviation aluminum material
Installation location: Rear license plate lamp is in the minddle
Operating voltage: 8-36V
Waterproof grade: IPX4
Suitable models: General motors
Install and connect to the line: license plate lamp,rear fog lights,brake lights,warning lights.
Prodect detail display
1.the use of aviation aluminum shell: Heart treatment strenthening effect is good, in the following 150 degrees have good strength,and there is a particularly good low temperature strength.
2.the United States Kerui lamp: Small size,long life,light,color temperature standard.Car achiever the prefect in the high drive current under high binding.
3.HD lens: Imported HD lens,strong penetrating prower,dear and grogeous pattern,perfect presentation.
4.Quartz Glass lens: Using quartz glass lenses,never fade,can be customized LOGO,advertsing etc...
5.Non pole protection drive: 8-36V wide voltage high power driver not only to play a protective role in the LOGO lights,but also for the original car line to strengthen prodection,play a role in constant current regulator.
6.Product matching: LOGO light host,3M glue,angle adjusting bracket.
Product material comparison
1.The products on the market,the film,2 hours continous use,severe fading,no pattern.
2.Our product,the use of quartz glass leness,the pattern is clear and bright,never fade
3.The use of film lens lit 2 hours after effect.
4.The use of quartz glass leness for 2 hours after the effect.
1.the first removal of the tail box interior board buckle,take off the interior
2.remove the LOGO host,the host is posted on 3M glue(recommended by A lighting burning 3M glue can paste firmly)
3.fixed in the middle position of the license plate.
4.the connection line to hide into the tail box.
5.find the need to install the line,can be fonnected with the license plate lamp,rear fog lights,brake lights,and hazard warning lights on the line.
6.LOGO lamp connection line regardless of the positive and negative,find the connection after installation can be used,and tape wrapped.
7.the host at both ends of the small hole can adjust the direction of LOGO.
8.the installation is completed.