DX  » wireless module »  view all wireless receiving module » wireless receiving module

wireless receiving module

Customers Who Bought wireless receiving module Also bought

The wireless receiving module your looking for is one of our top sellers. Dx offers a range of products from consumer electronics to outdoor sports gadgets and so much more. At DX there is something to suit everyone. May you have a great shopping experience with our worldwide free shipping.
Related Hot Products: wireless module controller

wireless receiving module Customers Reviews

  • Cool Receiver

    posted by bpetreski

    For the price it is the best. I'm very happy about this receiver. No problem at all.The quality could be better but it's not too bad. It comes without the instructions but you can easly figure out how to navigate.
    nothing else then.The other great thing is you can turn it off via the MCU. You don't have to uplug it and it's always there ready to use. Very convienient.
    Its a great receiver and the quality of the signal is OK! It's a bit better than other receiver who is similar like this
  • Good receiver for the price

    posted by AllgoodnameRgon

    Good quality for the price. It'll work at a nice range if you add an antenna (the place to solder the antenna is identified on the board).Also it is really small so it could be hidden if you wanted to.
    If you solder a 24AWG wire (10 to 15 centimeters long) to the ANT solder point (upper right corner of the board if you look at the picture on the product page), you'll extend the distance. I strongly suggest you do that, it's easy to do and takes about 10 seconds.
    If you want to make 2 arduino talk to each other wirelessly, get this thing and 149254.
  • Works as expected

    posted by thehog

    Just works as expected. Antenna thing which needs to be placed correctly contains a small tape which holds it in place on the battery.
    The chargedpad could be made bigger. As the galaxy S III is a large phone, it almost covers the whole pad. If it was bigger you could just drop your phone on the pad more easier instead of placing it correctly on the pad now. Also a bigger pad could charge more phones at a time.
    Works as expected. Nice to have if you don't want to plug in your phone in the charger all the time. Just place the pad on your desk or where you will normally drop your phone and the phone gets charged.
  • Very good item

    posted by marenas

    The device works in large distance. It is easy to instal into the breadboard. Stable signal is issued. Wide application, because there are four outputs with 3.5 V voltage. The standard operating frequency can be easily tied to the control module, standard RC remote control, thus allowing the device utilization.
    The device can be used to drive 5V relay. It can also be used as a simple one-way switch.
    The device according to their potential is worth the price.
  • Works

    posted by microdomenic

    No more cables!!wireless charing!Easy to install!
    If you have the skils to put some wires from the connectors on the phone to the s-view cover. it should work again. I didnt to it, just switched to another cover while I'm wondering if I should spend the $45 to get an original s-view cover with wireless charger included.
    Bottomline is that this module does what its supposed to do. It charges the phone wireless. Its nice just to lay the phone flat on my desk and it charges.

DX Everywhere