DX  » view all wire repair » wire repair

wire repair

Customers Who Bought wire repair Also bought

Every single wire repair displayed here is of a high level and the price is reasonable. We hope every customer enjoys their shopping experience at DX.com. DX is the world leader in electronic gadgets.

wire repair Customers Reviews

  • Decent quality solderable magnet wire

    posted by SleepyEng

    - The wire seems to be of decent quality- The spool has notches pre cut in the edges so that you can stop the wire from unrolling when not in use- The enamel coating seems to burn off a bit more easily than common magnet wires, but this could also be due to the thinner gauge of the wires compared to what I normally work with
    Works as expected.
    Works as expected, but a quick dip in flux before soldering helps quite a bit for this product.
  • Good replacement for ps2 flex

    posted by NobuX

    It's a good product like original ones. Works perfectly when your old flex circuit scratch your disc or when you have a dammage wire. It's easy to replace, theres no science on it.
    No other thoughts.
    It's a good product but I don't recommend to buy this one if you need more than one. So try searching for another flex ribbon.
  • Broken ribbon cable? Take this one!

    posted by XDr4g0nX

    -Cheap replacement of the old broken ribbon cable on your Nintendo DS
    -One side is completely covered with a small layer, this makes it more durable than the original ribbon cable
    Remember how your old ribbon cable sits in the housing! If you put it back in wrong it can break or tear the first time you close/open the screen.
    Excellent replacement ribbon cable for this price, better then any other i found on the internet so far.
  • Excellent

    posted by PieterT

    Easy to install. Price has just been reduced - thus very cheap.Does the job perfectly.
    Please note:No glue included to glue it in place - I used a good quality superglue, but only if you use very, very, very small amount - if unsure rather use a contact adhesive or phone specific tape glue.Packaged with protective film on both sides - remember to remove the inside film before installation, and to wipe with a dry cotton cloth, as the film leaves some residue.Be carefull for fingerprints on the inside, otherwise you will have to open the phone again!
    You only need a torx screwdriver, youtube instructions and patience.Very good buy.
  • Pretty Good, but...

    posted by sliversurfer

    I did a full disassemble and reassemble with a new case. The directional button bus fit as it should with high quality 3M adhesive backing included. The action buttons bus fit as it should with high quality 3M adhesive backing included. The plastic is good quality and not brittle folds nicely where needed. The direction and action buttons functioned perfectly.
    Still a bargain but frustrating that the Psp is not fully functional until I get new parts. *Be warned that the volume bar ribbon may not fit properly*. I am going to order several redundant parts as replacement for my next mods and repairs simply because the parts cost is minimal compared to the frustration of having to order wait and tear down my psps in a month.

WHY CHOOSE DX.COM?

Get great weekly deals and offers like: Collections