DX  » view all test leads » test leads

test leads

Check out the great test leads to see if there is any that suits you. At DX all products are checked in the quality control department before being packed and sent to you. What are you waiting for? Buy now!

test leads Customers Reviews

  • QA and layout of the ends could use work

    posted by slePP

    These are exactly what I was looking for to attach to circuits under test without having to hold probes. Has a banana jack to attach these and another set of probes at the same time.
    Even with the twisted pin, it is still able to attach to the circuits, but the shroud doesn't close properly around the tip.
    Not bad, though they seem a bit expensive for the quality and what they are.
  • Good upgrade-quality test leads

    posted by bhansenbhansen

    I have now been using the three pairs I bought for more than a month. I am still happy with them: the leads are plenty long, the tips are sharp enough, and the handles comfortable.
    the enclosed tip protectors are nice, though I suspect I will lose them soon :-)
    Recommended as a replacement or upgrade from the standard leads that come with economy multimeters.
  • Great SMD probe leads

    posted by ekilachkoff

    Very sharp needles, good for small contacts like those on small ICs and SMD passive elements. Scratches oxidation layer easily so it will make good contact. Flexible cable (though not as flexible as silicon wire would be, still better than most stock probes). Usable length is about 85cm (the probe itself is ~15cm, connector is ~5cm so it adds up to 105cm total length).
    Fits my UT-61E nicely.Cables are 1000V CAT II rated, this means it cannot be used in unprotected circuit (an automatic circuit breaker is needed). Still good for small electronic work though, just don't use them on building-level mains installation.Cable resistance is about 0.15 Ohms, so I believe 20A rating is only for short-term measurements.
    Great upgrade from bundled probes, a definite buy if you do any SMD electronic work.
  • Great deal

    posted by Magik79

    Absolutely perfect, genuine item. These are basic leads, no bells or whistles, but perfect for all standard use - electrical or electronic. These are 1/3 of the price of local Fluke versions (different models) and are perfectly adequate.
    None - pretty simple item, which is as expected.
    Very happy and am more than satisfied. I am happy to recommend and I'm also pretty sure they are genuine Fluke, but specifically for the Chinese market.
  • Great cables

    posted by nagyra

    - the cables are long enough- much better then the cables what are included to the cheap multimeters (eg. DT series)- the resistance is ~1 Ohm (measured with cheap mm: DT9205)
    This is much better than the included cables with cheap multimeters and it is much longer so very comfortable to use it. Recommended for home and half-professional using.
    None.

WHY CHOOSE DX.COM?

Get great weekly deals and offers like: Collections