DX  » stepper driver » view all stepper driver controller » stepper driver controller

stepper driver controller

You'll find the best stepper driver controller for you here. DX offers coupons that allow you to enjoy lower prices. Find your beloved cool gadgets right now.

stepper driver controller Customers Reviews

  • Works very well

    posted by ziloot

    This is very good bipolar CNC driver controller. Works with 5v power supply, doesnt sink to much current. Very durable and reliable.
    The project I realized CNC driver with L6203 is from here http://www.cuteminds.com/index.php/en/l297l6203. Used that schematic, and everything works. Instead of 0.33Om 2W sense resistors, put 0.33Om 5W, and big cooler with fun on L6203 pair (can be used one for both)
    Cheap and reliable CNC bipolar driver controler. Worth of use.
  • very useful

    posted by fervenceslau

    An inexpensive and useful solution to drive motors without the con of making your own driver module.
    The jumper beside the 7805 turn on this voltage regulator and puts the enable pins and the +5v in high state.Be sure that if you use a voltage higher than 5v for the motors, with this jumper on, the voltage regulator will get warm.
    If you want a cheap driver to play around and not get angry trying to make your own then buy this, its a must have ;-).
  • Drives motors OK

    posted by pc00007

    The board isn't too big and is simple to use. The on/off button is useful and there is no problem driving motors.The construction looks ok with no obvious visual defects
    There are no schematics supplied with the board. I'm not sure what the LED problem might be without schematics as I can't see without dismantling the board.
    The board is cheap, looks ok, and mostly it works ok.
  • Small, cheap and good quallity

    posted by korlenn

    Great price. Small as i expected. Good quallity at this price.
    If you make an analogy between L298 and L9110, L9110 can see that the does not have enable/disable pin.In other words is simply connected to the Arduino, in my case.External power supply must be used to avoid power problems.
    Connect with an Arduino Mega (bought from DX) works very fine with 2 micromotors.

WHY CHOOSE DX.COM?

Get great weekly deals and offers like: Collections