DX  » motor driver » view all motor driver controller » motor driver controller

motor driver controller

These cool motor driver controller are high quality and at affordable prices. DX is the leading electronic products provider in the world where millions of people shop daily. Your satisfaction is our reason for working harder and we aim to make your shopping experience easy and pleasant.

motor driver controller Customers Reviews

  • Works very well

    posted by ziloot

    This is very good bipolar CNC driver controller. Works with 5v power supply, doesnt sink to much current. Very durable and reliable.
    The project I realized CNC driver with L6203 is from here http://www.cuteminds.com/index.php/en/l297l6203. Used that schematic, and everything works. Instead of 0.33Om 2W sense resistors, put 0.33Om 5W, and big cooler with fun on L6203 pair (can be used one for both)
    Cheap and reliable CNC bipolar driver controler. Worth of use.
  • no problem works for me

    posted by mariusrdv

    Received device was as is in the photos(same colors and so on). Heat sink is really helpful(because I am driving two DC motors at 5V and motors has more than 2amp stall current ), so no problem at all. After intensive usage heat sink becomes warm/hot. Device has five red leds:one for power and others for IN1 IN2 IN3 IN4 high signals indication.
    Please share some documentation
    This is lower price for sure. Thinking about second :)
  • Works as expected, and at a very affordable price

    posted by netiness

    It was cheap, less than the price for a L298 chip alone in my country.I had no problem hooking it up to a stepper motor, and the onboard 5V supply regulator comes in handy for supplying other parts of my project.Each output as a green led associated with it so you can verify the stepping sequence,It also have a switch that can be used to shut off the controller board.
    I'm using this board connected to a parallell port. Hook a common ground to the GND part of the power terminal, then signal the IN pins in correct order to step the motor.
    Useful, cheap, and of acceptable build quality. I will be buying more of these because it was so easy to use.
  • Small, cheap and good quallity

    posted by korlenn

    Great price. Small as i expected. Good quallity at this price.
    If you make an analogy between L298 and L9110, L9110 can see that the does not have enable/disable pin.In other words is simply connected to the Arduino, in my case.External power supply must be used to avoid power problems.
    Connect with an Arduino Mega (bought from DX) works very fine with 2 micromotors.

WHY CHOOSE DX.COM?

Get great weekly deals and offers like: Collections