DX  » female connector »  view all female pin connector » female pin connector

female pin connector

The female pin connector your looking for is one of our top sellers. Our customer service team will repond promptly to your questions, making your shopping experience stress free and easier. What are you waiting for? Buy now!

female pin connector Customers Reviews

  • Cheap USB connectors

    posted by GeeJiiZet

    Quite cheap with only about 0.12 USD a piece, but they work fine and can be soldered to any standard dot matrix prototyping circuit boards.
    There are no markings which pin is which (VCC, D+, D-, GND), so make sure to double check the pin layout from external resources.
    These are the standard female USB 2.0 sockets you see on computers. If you need to replace one or need some in your DIY projects, these are cheap and suitable for that. I can't vouch for their durability, though.
  • Great Price for DIP USB mini sockets

    posted by Whamodyne

    Allows you to use USB power in your projectsDIP pins can be hand solderedUnused data pins can be removed
    A great price on a commodity item - I'm using this and a USB cord to power a lot of electronic projects.
    For using as 5V power to your project it's great. Looking at it from the rear, the far right pin is the positive 5V, and the far left pin is ground. The three middle pins are for data and can be pulled out with a pair of pliers if you don't need them
  • Good connectors at a good price

    posted by AlekseyEnergo

    Good price for the unit, but it could be lower.
    Price is not the lowest but not very bad, found in stores less expensive options in the same capacity. So that is where the seller is level. It is still recommended to purchase as well as the low price is not common. And here it is well below Most of the competitors. Bent legs easily rectified with tweezers, so it's not terrible delivery, but you have to consider it.
    Good connectors at a good price
  • Good Purchase

    posted by OldRock

    Inexpensive, simple,and well constructed adapter, this will turn any OBD II reader in to a Mercedes Benz diagnostic tool.
    Useful in any workshop and car garage, solves the problem of Mercedes using different adapters from other brands.
    Anyone who has a Mercedes Benz, can turn a cheap diagnostic tool in a new one for the MB brand.
    So cheap, that it is a mistake not to have it. No excuse whatsoever.
    Very good. A must have.
  • Does its job nicely.

    posted by ekilachkoff

    Looks well built and solid. Price is good. My batch arrived in good condition, no defects, no issues.
    Solder pad matches Molex 47589-0001 device. Indeed, this is only a surface mount device, so if you need to use it in a breadboard project, make yourself a breakout board (there are cheap PCB houses out there). This may also work for repairs, but I haven't had any devices with micro USB problems so far.
    Nice to have in a DIYer's shack.

DX Everywhere