DX  » driver mode » view all driver 5 mode » driver 5 mode

driver 5 mode

Customers Who Bought driver 5 mode Also bought

Buy a driver 5 mode from DX.com! It's your best choice. As your loyal companion, you'll find thousands of cool gadgets here at DX. DX is the world leader in electronic gadgets.

driver 5 mode Customers Reviews

  • 3*7135 chips

    posted by espimones

    7135 chipsRegulatedMemoryReal output advertised
    This regulator drive out fairly steadily 1.4 amps. in max. mode.Exactly: 1.35 in high mode, 0.4 in middle, 0.6 in low (fluctuating in sos and fast strobe modes).I have put it, working together with a 16 mm alu base Cree R5 led in my Trustfire TR-801, and it bright now 25%-30% more than the original Cree Q5 led, giving a really flood light!According Cree data sheets, Cree R5 can hold up 1,5 mA, so this regulated circuit is perfect to this led. Other drivers that can only drive up 1000 Ma, will give 25% less light tan this.
    I recommend it
  • Smoked mine and it still works!

    posted by bear123

    - durable - drives XML-t6 very well - cheap and reliable - good run time with 2 x 18650s - good run time with 4 alkaline (1.5v) x C cells and up to 8 alkaline C cells for serious run time!
    This is a great driver. I have a flashlight host that I have been trying different configurations that I have many extension tubes for. I made a 10 x C cell configuration using alkalines and this driver started to smoke. LOL. It was my mistake and not the driver. I stopped within seconds and the driver still works great! The voltage rating is 3-12v so I was pushing it a little to hard with 15v hence the smoke. As for the other reviewer, the difference between 2.3a to 2.5a inst worth the hassle to be honest. I run this driver stock and it is just as bright as any of my other xml t6 flashlights. 0.2 amp might be about 30 lumen less with an 800lm xml t6 and considering you need to quadruple lumen output to double the light intensity to your eye it wont be noticeable enough to matter imo.
    For the price this is a great driver for my XML T6. As a replacement driver or a DIY project this wont disappoint! any its tough! I burned mine and its still working no problems! lucky I guess lol. Maybe I will make a 12v D cell light and go for crazy run time with this! hahaha
  • Good driver for the modernization of the flashlight

    posted by Bezpieka

    Well done soldering.Good stabilization of the current at the specified range of supply voltage.Seamlessly cooperation with LED CREE XM-L2 U3
    Little short cable for flashlights witch variable focal length. When soldering thicker wires is needed soldering iron with temperature stabilization. There are likely to damage the driver.About 40 minutes of operation at full power on a single low-quality battery 18650
    Nice to use product for hobbyists that you can change parameter of your old flashlight.
  • Driver Board

    posted by innov57a

    Excellent driver. Quality of installation the very high! Put this driver in a flashlight on cree xm-l t6 light-emitting diode, thus brightness considerably increased in comparison with the native driver of this flashlight. One of advantages that there is a choice of a set of modes. Still I want to note high efficiency, checked in all modes, quantity of allocated heat so low that the radiator isn't necessary. I recommend to all who likes to finish all the hands
    the best price for this product!
    highly recommend!

WHY CHOOSE DX.COM?

Get great weekly deals and offers like: Collections