DX  » cable testing »  view all cable test multimeter » cable test multimeter

cable test multimeter

The cable test multimeter your looking for is one of our top sellers. DX has an excellent returns and exchange policy to protect our customer's rights, providing a secure shopping environment. With your support, we can do better.

cable test multimeter Customers Reviews

  • Chuffed!

    posted by Magik79

    Great product and the quality is not bad at all. Sturdy construction with good connectors and decent wire used.
    It would be handy if there were more tech details on the connectors - I bought spring clips to go with this and they have 2 different connector types. This has banana connectors on both ends, while the spring clips have a thread for the end of a probe. But I was able to mod things and get it to work.
    Happy - good product for a decent price.
  • Great SMD probe leads

    posted by ekilachkoff

    Very sharp needles, good for small contacts like those on small ICs and SMD passive elements. Scratches oxidation layer easily so it will make good contact. Flexible cable (though not as flexible as silicon wire would be, still better than most stock probes). Usable length is about 85cm (the probe itself is ~15cm, connector is ~5cm so it adds up to 105cm total length).
    Fits my UT-61E nicely.Cables are 1000V CAT II rated, this means it cannot be used in unprotected circuit (an automatic circuit breaker is needed). Still good for small electronic work though, just don't use them on building-level mains installation.Cable resistance is about 0.15 Ohms, so I believe 20A rating is only for short-term measurements.
    Great upgrade from bundled probes, a definite buy if you do any SMD electronic work.
  • Great Lead Test with right Lenght

    posted by jossdorn

    Robust construction and wire used. Both ends come with protection for storage against oxidation. The price is fair for the quality.On my multimeter it showed 0.1 to 0.2 ohms (oscilating among both values) at short circuit. The lenght is far enough for the usage at services, leaving the multimeter protected against undesirable crashes.
    I am happy with the investment I made in these Test Leads.
    This Test Leads I would reccomend to anyone who wants a good leads to use with his/her multimeter. It worths its price.
  • Useful

    posted by ArChAng3L

    I had some difficulty finding this item in my country. I just had to buy it from DX and the item arrived in my mailbox after a week. The plugs are universal and fits in both multimeters that I have.
    It's cheap, but it could be cheaper for a couple of clips, plugs and wires. Wires could be made to be thicker
    Will definitely buy it again when my set of wires fail or when I need more. Don't hesitate to buy it if you need it.
  • QA and layout of the ends could use work

    posted by slePP

    These are exactly what I was looking for to attach to circuits under test without having to hold probes. Has a banana jack to attach these and another set of probes at the same time.
    Even with the twisted pin, it is still able to attach to the circuits, but the shroud doesn't close properly around the tip.
    Not bad, though they seem a bit expensive for the quality and what they are.

DX Everywhere