DX  » stepper motor driver » view all arduino stepper motor driver » arduino stepper motor driver

arduino stepper motor driver

Customers Who Bought arduino stepper motor driver Also bought

You can buy cheap arduino stepper motor driver from us. DX is an E-commerce online retailer situated in China with more than 100,000 cool gadgets with free worldwide shipping. We hope that you have a fulfilling shopping expreience, on China's leading e-commerce retailer website.

arduino stepper motor driver Customers Reviews

  • Small, cheap and good quallity

    posted by korlenn

    Great price. Small as i expected. Good quallity at this price.
    If you make an analogy between L298 and L9110, L9110 can see that the does not have enable/disable pin.In other words is simply connected to the Arduino, in my case.External power supply must be used to avoid power problems.
    Connect with an Arduino Mega (bought from DX) works very fine with 2 micromotors.
  • Microstepping stepper driver

    posted by chuank

    This looks to be the original EasyDriver V4.4 Stepper. That's probably the reason why the price is steeper.I like the fact that it comes without header pins unsoldered – that way I can adapt it to my project.Based on the Allegro A3967 controller. Microstepping, sleep mode, all-in-one package for bipolar motors.
    You will need to heatsink this guy to get any useful output on your steppers.Works very well with Arduino and other microcontrollers. This is a cheaper version to the newer BigEasy driver.Specifications of this board can be found here:http://www.schmalzhaus.com/EasyDriver/index.html
    If you're tired of the limitations of the L298N or ULN2003-based steppers, try these out. Way better control and microstepping functionality awaits.
  • good product

    posted by fabio1964

    This is a very nice little L298 carrier board. It has (very bright) red status LEDs for the 4 inputs, as well as jumper-enable-able pull-up resistors on the inputs.
    No manual. Can't see the reason for pull-up resistors on the inputs(see other thoughts). For security reasons I would put pullDOWN resistors, if any. Plastic parts of the screw terminals are somewhat loose on my board (I bought only one), but that does not caused any problem. Got the same problem with supplies over 20V as FakeName describes
    At this price it can't get any better! if you are looking for a great h-bridge to control couple motors this is a sure bet

WHY CHOOSE DX.COM?

Get great weekly deals and offers like: Collections